Wood Working - Part 2 Crossword Puzzle
Download and print this Wood Working - Part 2 crossword puzzle.
Related puzzles:
Browse all Tools / Equipment Puzzles
QUESTIONS LIST:
- miter saw : a handsaw used with a miter box; a power saw, similar to a circular saw, that cuts miters
- groove : a three-sided trench cut with the grain of a board.
- shim : a thick wedge of wood used to fill a gap or make a surface level
- spline : a narrow strip of wood that is glued in corresponding grooves to join pieces of wood
- root : the portion of a screw length below the head that has threads on it
- ferrule : a metal ring secured around a smaller piece of metal or wood to reinforce it.
- biscuit : a small wafer of wood that is inserted and glued to an edge groove between two pieces of wood to be joined
- carbide : a combination or iron, carbon and alloy metal (usually tungsten) used to make hard, brittle but long-lasting material used for cutting edges of bits and blades
- pilot hole : a small hole drilled in your work that is intended to guide a fastener.
- planer : power tool used to carve thin slices from a board to straighten or square a surface or edge
- truing : the act of making true, as in square, flat, concentric or balanced
- softwood : the wood of any coniferous tree
- off cut : a waste piece of lumber
- rip cut : a cut parallel to the grain of a board.
- heartwood : mature wood that forms the spine of a tree
- gouge : a chisel-like turning or carving tool with a curved edge
- lathe : machine used for turning wood on an axis
- back saw : a hand saw that is stabilized with a rigid spine along the back of the blade
- apron : the part of a table between the legs that attaches the base to the top
- jigsaw : a power tool using a vertical, reciprocating blade; used for cutting different kinds of materials depending on the type of blade used
- turning : refers to work done on a lathe
- shank : the shaft of a bit or cutter that is gripped in a tool by a chuck or a collet
- dowel : a cylindrical length of wood used for making joints by inserting a length into two corresponding holes and gluing with clamp pressure